Helms Deep Print Single Piece.

3D Model

Ive included the OBJ and 2 lychee files, unfortunatly the blender file is too large.

Im one and done with this and wont be updating this with any changes.

Picture found here of my first attempt. https://www.reddit.com/r/blender/comments/1h8m8ms/learn_geometry_nodes_and_used_scatter_to_3dprint/#lightbox The corners bowed on the first print due to not having enough corner supports. For a better print you could try thinning the base so its easier to flatten. For my bowed prints I used warm water to heat it up so it would flex, then glued and clamped it flat onto a base to keep it from bowing again.

The top side of the model doesnt need any supports. If you dont like the lychee file or use a different slicer, the print was done at 10 degrees with the wall high side, and a right to left angle (roll) of 1 degree.

Have fun :)